These are NEW professional quality ground finish straight flute general purpose tools which can be used for both machine or hand tapping. They are generally the most economical tool for use on production runs, but are best on materials that produce chips, or where the swarf breaks readily. Where deep holes are to be tapped, in materials which produce stringy swarf, other types of taps may be needed, especially for coarse threads. TAPER TAPS have a lead of 7-10 threads at 5 degrees per side. The taper lead distributes the cutting force over a large area, and the taper shape helps the thread to start. They can therefore be used to start a thread prior to use of second or bottom leads, or for through holes. IMPORTANT NOTE ON TERMINOLOGY! In the U.K. bottom taps are often referred to as ‘plugs.

These are NEW professional quality ground finish straight flute general purpose tools which can be used for both machine or hand tapping. They are generally the most economical tool for use on production runs, but are best on materials that produce chips, or where the swarf breaks readily. Where deep holes are to be tapped, in materials which produce stringy swarf, other types of taps may be needed, especially for coarse threads. BOTTOM TAPS have a chamfer (lead) of 1–2 threads, the angle of the lead being around 18 degrees per side. They are used to produce threads close to the bottom of blind holes. IMPORTANT NOTE ON TERMINOLOGY! In the U.K. bottom taps are often referred to as ‘plugs’. In North America second taps are often referred to as ‘plugs’! This can easily lead to confusion. To a.

Untitled Document Metric HSS Circular Split Die M12 x 1.75 1″ OD 12 mm DIES are usually round and are used for cutting external threads. They can be held in a Die Stock for hand operation or in a Die Holder for use by machine. Dies are usually split which enables adjustment for precision, and also to extend the life of the die as it wears. The lead at the front (etched) face is normally 3 pitches, for standard threading, and 2 pitches at the back face for closer threading, or soft materials. Industrial Quality Split Die in HSS 1.0″ OD .